2009:New Sensor Mounting Ideas: Difference between revisions

Revision as of 14:03, 28 February 2009

Desired to retrofit robot with shaft rotation sensors on the conveyors (one on front and one on rear).
Probably use Omron photoreflective sensors? We have two of them.
One place to moutnt sensor near shaft is where the shafts extend out the sides if the robot (opposite side from electrical board), so the sensor won't be anywhere near where the balls are going up the conveyors. This does however expose them to damage from collisions with other robots (?)
Here are a couple of mounting ideas:

We might also want to try to use the shaft supports somehow, bolting to the same slots so that we don't have to drill new holes? Like this maybe?

@@ Line 2: / Line 2: @@
 *Probably use Omron photoreflective sensors?&nbsp; We have two of them.
 *One place to moutnt sensor near shaft is where the shafts extend out the sides if the robot (opposite side from electrical board), so the sensor won't be anywhere near where the balls are going up the conveyors.&nbsp; This does however expose them to damage from collisions with other robots (?)
-*Here are a couple of mounting ideas:&nbsp;&nbsp; [[Image:Robot shaft sensor 001.jpg|border|400px]]
+*Here are a couple of mounting ideas:&nbsp;
-*We might also want to try to use the shaft supports somehow, bolting to the same slots so that we don't have to drill new holes?
+[[Image:Robot shaft sensor 001.jpg|border|400px]]&nbsp;
+<br>
+*We might also want to try to use the shaft supports somehow, bolting to the same slots so that we don't have to drill new holes?&nbsp; Like this maybe?&nbsp;
+[[Image:Sensor support bracket.jpg|border|600px]]&nbsp;