2011:Controls 2.13: Difference between revisions
From 1511Wookiee
Jump to navigationJump to search
(New page: = Attendance = '''Start time: ''' '''End time: ''' '''Members present: ''' '''Members Attending Next Meeting: ''' = Tasks Completed = *task **sub-task **sub-task *task = Tasks In Pr...) |
No edit summary |
||
| Line 1: | Line 1: | ||
= Attendance = | = Attendance = | ||
'''Start time: ''' | '''Start time:11AM''' | ||
'''End time: ''' | '''End time: ''' | ||
'''Members present: ''' | '''Members present: Crystal, JP, Eric, Gafei ''' | ||
'''Members Attending Next Meeting: ''' | '''Members Attending Next Meeting: ''' | ||
= Tasks Completed = | = Tasks Completed = | ||
* | *Finished wiring the controls onto the actual sheet metal interface | ||
* | *Fixed miscellaneous wiring issues (3 way toggle switch LEDs were reversed, soldered yellow/white pin back onto ribbon connector, Replaced a broken 2-way toggle switch, covered resistors with electrical tape)<br> | ||
** | *Painted the yellow thunderbolt<br> | ||
* | *Implemented cable management with cable ties onto the the electrical controls<br> | ||
*Tested the toggle switch LEDs, signal light LEDs and control | |||
*Mounted saitek arm/manipulator joystick with velcro onto the sheet metal<br> | |||
*Determined the correct timing for the pontentiometers (from ADC) for the autonomous delay. It's 32-bits and not 8-bits. | |||
= Tasks In Progress = | = Tasks In Progress = | ||
* | * Program the known controls correctly with the cypress board | ||
= Tasks to Complete = | = Tasks to Complete = | ||
* | *Find a way to protect the bottom of the control interface. | ||
** | **Lexan is currently being considered. | ||
** | **Possibly split the lexan into different "zones" with bars to mount the lexan. | ||
= Materials Needed = | = Materials Needed = | ||
* | *Lexan for the bottom of the control interface. | ||
Revision as of 16:49, 13 February 2011
Attendance
Start time:11AM
End time:
Members present: Crystal, JP, Eric, Gafei
Members Attending Next Meeting:
Tasks Completed
- Finished wiring the controls onto the actual sheet metal interface
- Fixed miscellaneous wiring issues (3 way toggle switch LEDs were reversed, soldered yellow/white pin back onto ribbon connector, Replaced a broken 2-way toggle switch, covered resistors with electrical tape)
- Painted the yellow thunderbolt
- Implemented cable management with cable ties onto the the electrical controls
- Tested the toggle switch LEDs, signal light LEDs and control
- Mounted saitek arm/manipulator joystick with velcro onto the sheet metal
- Determined the correct timing for the pontentiometers (from ADC) for the autonomous delay. It's 32-bits and not 8-bits.
Tasks In Progress
- Program the known controls correctly with the cypress board
Tasks to Complete
- Find a way to protect the bottom of the control interface.
- Lexan is currently being considered.
- Possibly split the lexan into different "zones" with bars to mount the lexan.
Materials Needed
- Lexan for the bottom of the control interface.
