Latest revision as of 15:41, 5 February 2011

Attendance

Start time: 11AM

End time:

Members present: Crystal, Eric, Gafei

Members Attending Next Meeting:

Wiring of the switches, LEDs, and resistors were completed for the swtitch "matrix."
- LED resistance values were calculated for each specific LED color. (Vin - Vled / 20mA) = Rled ) (Vin is 5V from the cypress board)
The autonomous keypad was wired.
Preliminary mapping and emulation of a HID device was implemented through the cypress board.

Determine where to add potentiometer holes on the paper layout.
- Wire the LCD panel and make sure it works.
- Get the autonomus keypad to work correctly.

A sheet metal layout is in going to be needed.
- Preset switches need to be wired.

@@ Line 13: / Line 13: @@
 *Wiring of the switches, LEDs, and resistors were completed for the swtitch "matrix."<br>
 **LED resistance values were calculated for each specific LED color. (Vin - Vled / 20mA) = Rled ) (Vin is 5V from the cypress board)
-*Preliminary mapping of some of the controls were completed on the cypress board.
+*The autonomous keypad was wired.
+*Preliminary mapping and emulation of a HID&nbsp;device was implemented through the cypress board.
 = Tasks In Progress  =
 *Mapping of the I/O's to the cypress board is in progress.
-**sub-task
-**sub-task
-*task
 = Tasks to Complete  =
 *Determine where to add potentiometer holes on the paper layout.<br>
-**Wire <br>
+**Wire the LCD&nbsp;panel and make sure it works.<br>
-**sub-task
+**Get the autonomus keypad to work correctly.
-*task
 = Materials Needed  =
-*task
+*A sheet metal layout is in going to be needed.
-**sub-task
+**Preset switches need to be wired.
-**sub-task
-*task