2011:Controls 2.5: Difference between revisions
From 1511Wookiee
Jump to navigationJump to search
No edit summary |
No edit summary |
||
| Line 12: | Line 12: | ||
*Wiring of the switches, LEDs, and resistors were completed for the swtitch "matrix."<br> | *Wiring of the switches, LEDs, and resistors were completed for the swtitch "matrix."<br> | ||
**LED resistance values were calculated for each specific LED color. (Vin - Vled / 20mA) = Rled ) (Vin is 5V from the cypress board) | **LED resistance values were calculated for each specific LED color. (Vin - Vled / 20mA) = Rled ) (Vin is 5V from the cypress board) | ||
*Preliminary mapping of | *The autonomous keypad was wired. | ||
*Preliminary mapping and emulation of a HID device was implemented through the cypress board. | |||
= Tasks In Progress = | = Tasks In Progress = | ||
| Line 24: | Line 25: | ||
= Tasks to Complete = | = Tasks to Complete = | ||
*Determine where to add potentiometer holes on the paper layout.<br> | *Determine where to add potentiometer holes on the paper layout.<br> | ||
**Wire <br> | **Wire the LCD panel and make sure it works.<br> | ||
** | **Get the autonomus selector to work correctly.<br> | ||
*task | *task | ||
= Materials Needed = | = Materials Needed = | ||
* | *A sheet metal layout is in going to be needed. | ||
** | **Preset switches need to be wired. | ||
Revision as of 15:40, 5 February 2011
Attendance
Start time: 11AM
End time:
Members present: Crystal, Eric, Gafei
Members Attending Next Meeting:
Tasks Completed
- Wiring of the switches, LEDs, and resistors were completed for the swtitch "matrix."
- LED resistance values were calculated for each specific LED color. (Vin - Vled / 20mA) = Rled ) (Vin is 5V from the cypress board)
- The autonomous keypad was wired.
- Preliminary mapping and emulation of a HID device was implemented through the cypress board.
Tasks In Progress
- Mapping of the I/O's to the cypress board is in progress.
- sub-task
- sub-task
- task
Tasks to Complete
- Determine where to add potentiometer holes on the paper layout.
- Wire the LCD panel and make sure it works.
- Get the autonomus selector to work correctly.
- Wire the LCD panel and make sure it works.
- task
Materials Needed
- A sheet metal layout is in going to be needed.
- Preset switches need to be wired.
