2012:Mechanical

Master Task List

Engineering Notebook Templates Available at: Engineering_Notebook_Template

Please Label All Notebook Pages 2012:Mechanical 2 MM.DD to avoid confusion.

 

 

'''Beater Bar''' http://www.mcmaster.com/#aluminum-hollow-rods/=fun3si

 

http://www.vexrobotics.com/products/vexpro/ifi-wheel-tread.html

Roughtop Tread 8" OD x 2" Wide ROUGHTOP-820 In stock

  Conveyor System:

  conveyor system pros and cons -

Design 1: Motors Only
Pros:
• Constant speed (assuming battery voltage does not drop dramatically)
• More space below the conveyor to accommodate the drivetrain transmissions and motors.
• Smooth transmission between different stages of the conveyor to the turret.
• Less possible states for the last stage of the design.
Cons:
• Cannot actually push the ball past the turret line. There needs to be a hand off so there will be a transition stage.
Design 2: Pneumatics and Motors
Pros:
• Need one less motor.
• Compressor is already on the robot.
• Higher handoff to the turret, goes past the turret line.
• Lower height than turret.
• When the supply is available, speed and force of ball feed will be consistant.
Cons:
• Takes up more space in the back bottom part of the robot.
• Requires ball to settle time into cup prior to firing.
• Lose contact with ball when going into last stage.
• Hard to manufacture the bowl for the launcher unless we buy it, work around could be square on point.
• Amy and Mr. Wolf feel that the linear action is more complicated than the rotary action.

 

 

Archives

2011 Mechanical Page2010 Mechanical Page2009 Mechanical_1 Page