2009:New Sensor Mounting Ideas: Difference between revisions
From 1511Wookiee
Jump to navigationJump to search
(New page: *Desired to retrofit robot with shaft rotation sensors on the conveyors (one on front and one on rear). *Probably use Omron photoreflective sensors? We have two of them. *One place t...) |
No edit summary |
||
Line 1: | Line 1: | ||
*Desired to retrofit robot with shaft rotation sensors on the conveyors (one on front and one on rear). | *Desired to retrofit robot with shaft rotation sensors on the conveyors (one on front and one on rear). | ||
*Probably use Omron photoreflective sensors? We have two of them. | *Probably use Omron photoreflective sensors? We have two of them. | ||
*One place to moutnt sensor near shaft is where the shafts extend out the sides if the robot (opposite side from electrical board), so the sensor won't be anywhere near where the balls are going up the conveyors. This does however expose them to damage from collisions with other robots (?) | *One place to moutnt sensor near shaft is where the shafts extend out the sides if the robot (opposite side from electrical board), so the sensor won't be anywhere near where the balls are going up the conveyors. This does however expose them to damage from collisions with other robots (?) | ||
*Here are a couple of mounting ideas: | *Here are a couple of mounting ideas: **when I can figure out how to import a scanned pic and not have it be HUGE** | ||
*We might also want to try to use the shaft supports somehow, so that we don't have to drill new holes? |
Revision as of 18:57, 24 February 2009
- Desired to retrofit robot with shaft rotation sensors on the conveyors (one on front and one on rear).
- Probably use Omron photoreflective sensors? We have two of them.
- One place to moutnt sensor near shaft is where the shafts extend out the sides if the robot (opposite side from electrical board), so the sensor won't be anywhere near where the balls are going up the conveyors. This does however expose them to damage from collisions with other robots (?)
- Here are a couple of mounting ideas: **when I can figure out how to import a scanned pic and not have it be HUGE**
- We might also want to try to use the shaft supports somehow, so that we don't have to drill new holes?