2015:Lifter Subteam

General Summary:

Uses Chain to lift car along rail.

Grippers are fixed on car and slide up and down rail.

2013 Design is being used as a reference point for design.

Weight Limit set at integration: 36 Pounds. Current Estimate: 36 Pounds (Integration Weight sheet)

Stabilizing Mechanism must be mounted near the top of the Lifter

Required Specifications:

Gripper Must move to a max height of slightly over 5 feet and as low as 10 inches from the ground (NOT FRAME)

Less than 36 pounds

Able to lift at minimum 41.9 pounds and a maximum of 57.5 Pounds

Keep CG as low as possible

Have a stable mounting position for the second gripper/stabilizer

Guide Rails up too 78 inches (6' 6")

Fast as Possible. (1 level per 2 seconds with load/ 1 Meter/Second)?

Is the Best part on the Robot.

Progress as of 1/13/2015 (10 Days Used/35 Remaining)

Design

55% Complete

Summary of 1/10/2015: Rough CAD begun and actuation design concepts complete (CAD pic)

Summary of 1/11/2015: Manuel Designs the lifter part 1.

Summary of 1/13/2015:

Summary of 1/14/2015:

Summary of 1/15/2015:

Manufature

0% Complete

Testing

0% Complete

Detailed Work Done on 1/10/2015

Rough Design started on CAD

Determined How it will be actuated (CHAIN)

CG Table (Located in Harris Robotics>2015> BUILD SEASON (ROBOT)> Other Design Documents) used to Find optimum mounting position ( As far FOWARD as possible without being past the front wheels)

Detailed Work Done on 1/11/2015

Detailed Work Done on 1/13/2015

Detailed Work Done on 1/14/2015

Detailed Work Done on 1/15/2015