Sheetmetal Parts at Harris

Bend Radius

All bent parts should have an internal bend radius of .032.  This is the radius that the model shop will use to bend the parts.

Common Material Thickness

The following is a list of material thickness that the model shop typically has on hand:

 -->  .032

 -->  .040

 --> . 062

 -->  .093

 -->  .125

Be sure to set the thickness properly in inventor parts (go to sheet metal defaults) and include on your drawings!

Submitting Sheet Metal Parts to Harris

Follow the instructions on the Fabrication page very carefully to prepare the files needed to have parts made at Harris.