2009:Drivetrain 1.7.2009

From 1511Wookiee
Jump to navigationJump to search

Drivetrain-1.07.2009

Start time: 6:00 pm

End time:  9:00 pm

Members present: Tony,  Goodman, Gannon, Larry, Matthieu

New bearings p/n r1212zz ordered.

Tony and Matthieu were show  drive wheel asembly.

ordered transmission

built up chassis frame


Tasks to complete: '

UPDATE

PLEASE PASS THIS ON TO THE MECHANICAL SUBTEAMS


Key ITEMS


  • 27.25” LONG x 37.25” WIDE
  • Rear wheel axis at 5.625 from most rear surfaces (adjustable down to 4.625 corner brace regime permitting)
  • Front wheel axis at 11.625 from front most surfaces (adjustable ± 2.00”)


  • Still need to determine a few hardware items but I think we could use a few PEM fasteners to further minimize fastener system weight
  • We will need to design a few spacers “on the fly” as we determine the best approach while building
  • The 6-hole patterns in the wheels need to be tapped for 10-32 Depth TBD
  • Need to add the stiffener element between the wheels (1/side 1”x1” ext. Al stock is light and will work well and can be welded)
  • Need to cut necessary smaller frame elements from stock
  • Need to design in provisions for front “dummy wheels” biased 1/8” up for roll over protection


  • Need to order the following parts from the shop by tomorrow:
  • 2009-wheel-hub (1/8 wheel retainer plate) QTY:4
  • Hub-bearing (just a spacer in the hub for support not a bearing) QTY:4
  • Brkt-wheel-asy-1 (trans/motor mount left front and right rear) QTY:2
  • Brkt-wheel-asy-2 (trans/motor mount left rear and right front) QTY:2
  • Bearing-block (main double bearing holder for each drive assembly) QTY:4



Drivetrain Main Page