Fabrication

How to Submit Parts

    In order to get parts made a drawing must be completed and the appropriate files must be submitted (see below for drawing and file requirements).  Please create a new link on this page (under files to be made) for each part request and include the proper drawing and required files.  Any questions at all, please ask Amy Averill.

                                                    Notice that to save in any of these formats, you must click on "Save Copy As".

---

    Drawing Requirements: (use the FIRST/Robotics drawing template under the English tab on the template menu).  Save a Copy As AUTOCAD .dwg (Autocad LT.)

                  List Material

                  State Quantity

                  Provide Overall Dimensions

                  Name of student who created the drawing

                  Current Date - this needs to be updated everytime a drawing is submitted to get parts made (this acts as the revision control)

                  *  If it is a sheet metal part to be bent, then the bend radius must be dimensioned along with the feature

                  * If the part will be welded, then care must be taken to design with the proper dimensioning scheme leaving room for the weldments

   'Additional 'File Requirements:

                 - Machined Parts (think parts with intricate surfaces) - .stp  

                 - OMAX Parts (think flat parts, bar stock to be cut to length) - .dxf

                                This is basically a stripped down version of the drawing.  It should include the face on view of the part (no other views) with no dimensions and should be scaled 1:1.  If the part is bent, then it needs to be shown in the unbent state. Then use Save a Copy As and save as a .dxf Autocad LT.

Files to be made

Date	Requested Item	Requestor	Ordered By/Date	QTY	RX'd
1/31/10	GOOD hook (long and skinny)	Richards		1
1/31/10	GOOD hook	Richards		1
1/31/10	GOOD hook [1]	Richards		1

Order Status

Date	Requested Item	Requestor	Ordered By/Date	QTY	RX'd
1/13/10	2010 Slot Chassis Brkt	Gannon	Averill 1/13/10	8	1/15
1/13/10	2010 Motor Mount SS	Gannon	Averill 1/13/10	4	1/15
1/13/10	2010 Rear Moto Cross Brace	Gannon	Averill 1/13/10	1	1/15
1/13/10	2010 Bearing Block 3_8ID	Gannon	Averill 1/14/10	4
1/15/10	2010 Camera Mount Sheet 1	Dora	Averill 1/14/10	1
1/18/10	2010 Camera Mount Bent	Dora	Averill 1/14/10	1

Parts Built Elsewhere

Date	Part Name	Where to Make	Builder/Date	QTY	RX'd

Archives

• 2009 Fabrication Page