2024:Programming
From 1511Wookiee
Jump to navigationJump to search
Daily Status
1/11/2024 Worked On:
Test Board
- Set up CAN Motor usage (encoder, motor, power distribution board)
- Began coding for motor usage
- Tested a motor using basic code
1/13/2024
Worked on:
KitBot
- Programmed drive
- Implemented Drive to test board
- Hooked up test board to KitBot
- Tank Drive Works :) (sort of)
- Programmed shooter/intake
- Implemented shooter to test board
- Shooter/intake works :) (intake is very strong)
- Programmed better shooter (goes farther/higher)
Test Board
- Hooked up to KitBot
We are probably done with KitBot, practice shooting was successful, including the pre-heat function. The team learned a lot and we had many successes. Notes: Don't forget to deploy robot code, Check can ids, and don't mess up the wiring stuff (labeling stuff is good). 1/20/2024 RIP Kitbot Worked on:
- Shooter Works!
- Sensor is mounted at the start of intake and detects note
| If the Intake Button is Pressed | Has Note | Does Not Have Note |
| Shooter Button Pressed | Can Run Intake at 100% | Can Run Intake at 60% |
| Shooter Button Not Pressed | CAN'T Run Intake | Can Run Intake at 60% |
- Shooter runs at 50%
- Outtake runs at 80%
